외장 하드 드라이브가 작동하지 않고 마운트된 파티션이 표시되지 않습니다.

하드 드라이브 모델: Western Digital My Passport 25E2 4TB 파일 시스템 NTFS

어제는 작동했는데 이제 연결하면 lsblk마운트할 파티션이 표시되지 않습니다. 다음과 같습니다.

sdb                  8:16   0   3.6T  0 disk

$ smartctl -a /dev/sdb:
Read Device Identity failed: empty IDENTIFY data

A mandatory SMART command failed: exiting. To continue, add one or more '-T permissive' options.

$ journalctl -f
kernel: ses 5:0:0:1: Failed to get diagnostic page 0x1
kernel: ses 5:0:0:1: Failed to bind enclosure -19
kernel: .............ready
kernel: sd 5:0:0:0: [sdb] Very big device. Trying to use READ CAPACITY(16).
kernel: sd 5:0:0:0: [sdb] 7813969920 512-byte logical blocks: (4.00 TB/3.64 TiB)
kernel: sd 5:0:0:0: [sdb] 4096-byte physical blocks
kernel: sd 5:0:0:0: [sdb] Write Protect is off
kernel: sd 5:0:0:0: [sdb] Mode Sense: 47 00 10 08
kernel: sd 5:0:0:0: [sdb] No Caching mode page found
kernel: sd 5:0:0:0: [sdb] Assuming drive cache: write through
kernel: sd 5:0:0:0: [sdb] tag#0 timing out command, waited 180s
kernel: sd 5:0:0:0: [sdb] tag#0 FAILED Result: hostbyte=DID_OK driverbyte=DRIVER_OK cmd_age=180s
kernel: sd 5:0:0:0: [sdb] tag#0 Sense Key : Hardware Error [current]
kernel: sd 5:0:0:0: [sdb] tag#0 Add. Sense: Internal target failure
kernel: sd 5:0:0:0: [sdb] tag#0 CDB: Read(16) 88 00 00 00 00 00 00 00 00 00 00 00 00 08 00 00
kernel: I/O error, dev sdb, sector 0 op 0x0:(READ) flags 0x0 phys_seg 1 prio class 2
kernel: Buffer I/O error on dev sdb, logical block 0, async page read

장치가 fdisk -lWindows 컴퓨터에 나타나지 않고 초기화를 위해 마우스 오른쪽 버튼을 클릭하려고 하면 초기화되지 않은 것으로 나타나고 하드웨어 오류가 표시됩니다.