저는 HP nc4400 노트북에서 Debian 7을 실행하고 있습니다. 이것은 Intel Centrino 칩셋이 탑재된 오래된 노트북입니다. 팬이 10초 동안 켜졌다가 20초 동안 꺼졌다가 10초 동안 켜졌다는 점을 제외하면 정상적으로 작동합니다.
BIOS에는 ACPI 또는 APM에 대한 언급이 없습니다. dmesg | grep -i "acpi"다음을 반환합니다.
0317)
[ 0.229900] ACPI: Dynamic OEM Table Load:
[ 0.229904] ACPI: SSDT (null) 001FB (v01 HP Cpu0Ist 00003000 INTL 20060317)
[ 0.230045] ACPI: SSDT 7f7f629b 004CB (v01 HP Cpu0Cst 00003001 INTL 20060317)
[ 0.230435] ACPI: Dynamic OEM Table Load:
[ 0.230439] ACPI: SSDT (null) 004CB (v01 HP Cpu0Cst 00003001 INTL 20060317)
[ 0.230701] ACPI: SSDT 7f7f5f53 000C8 (v01 HP Cpu1Ist 00003000 INTL 20060317)
[ 0.231101] ACPI: Dynamic OEM Table Load:
[ 0.231105] ACPI: SSDT (null) 000C8 (v01 HP Cpu1Ist 00003000 INTL 20060317)
[ 0.231211] ACPI: SSDT 7f7f6216 00085 (v01 HP Cpu1Cst 00003000 INTL 20060317)
[ 0.231603] ACPI: Dynamic OEM Table Load:
[ 0.231606] ACPI: SSDT (null) 00085 (v01 HP Cpu1Cst 00003000 INTL 20060317)
[ 0.244084] ACPI: Interpreter enabled
[ 0.244100] ACPI: (supports S0 S3 S4 S5)
[ 0.244121] ACPI: Using IOAPIC for interrupt routing
[ 0.244789] PCI: MMCONFIG at [mem 0xf8000000-0xfbffffff] reserved in ACPI motherboard resources
[ 0.245206] [Firmware Bug]: ACPI: No _BQC method, cannot determine initial brightness
[ 0.260264] ACPI: Power Resource [C220] (on)
[ 0.262871] ACPI: Power Resource [C228] (on)
[ 0.269881] ACPI: Power Resource [C329] (off)
[ 0.269959] ACPI: Power Resource [C32A] (off)
[ 0.270035] ACPI: Power Resource [C32B] (off)
[ 0.270113] ACPI: Power Resource [C32C] (off)
[ 0.270888] ACPI: EC: GPE = 0x16, I/O: command/status = 0x66, data = 0x62
[ 0.271132] ACPI: No dock devices found.
[ 0.271142] PCI: Ignoring host bridge windows from ACPI; if necessary, use "pci=use_crs" and report a bug
[ 0.274594] ACPI: PCI Root Bridge [C002] (domain 0000 [bus 00-ff])
[ 0.283058] pci 0000:00:1f.0: quirk: [io 0x1000-0x107f] claimed by ICH6 ACPI/GPIO/TCO
[ 0.285079] ACPI: PCI Interrupt Routing Table [\_SB_.C002._PRT]
[ 0.285255] ACPI: PCI Interrupt Routing Table [\_SB_.C002.C098._PRT]
[ 0.285357] ACPI: PCI Interrupt Routing Table [\_SB_.C002.C101._PRT]
[ 0.285421] ACPI: PCI Interrupt Routing Table [\_SB_.C002.C111._PRT]
[ 0.285491] pci0000:00: Requesting ACPI _OSC control (0x1d)
[ 0.285495] pci0000:00: ACPI _OSC request failed (AE_NOT_FOUND), returned control mask: 0x1d
[ 0.285498] ACPI _OSC control for PCIe not granted, disabling ASPM
[ 0.298542] ACPI: PCI Interrupt Link [C10D] (IRQs *10 11)
[ 0.298640] ACPI: PCI Interrupt Link [C10E] (IRQs *10 11)
[ 0.298735] ACPI: PCI Interrupt Link [C10F] (IRQs 10 *11)
[ 0.298829] ACPI: PCI Interrupt Link [C110] (IRQs 10 11) *5
[ 0.298923] ACPI: PCI Interrupt Link [C123] (IRQs *10 11)
[ 0.299016] ACPI: PCI Interrupt Link [C124] (IRQs *10 11)
[ 0.299110] ACPI: PCI Interrupt Link [C125] (IRQs 10 *11)
[ 0.299152] ACPI Exception: AE_NOT_FOUND, Evaluating _PRS (20110623/pci_link-184)
[ 0.299282] PCI: Using ACPI for IRQ routing
[ 0.306278] pnp: PnP ACPI init
[ 0.306293] ACPI: bus type pnp registered
[ 0.306470] system 00:00: Plug and Play ACPI device, IDs PNP0c01 (active)
[ 0.310002] pnp 00:01: Plug and Play ACPI device, IDs PNP0a08 PNP0a03 (active)
[ 0.310352] pnp 00:02: Plug and Play ACPI device, IDs IFX0102 PNP0c31 (active)
[ 0.310415] pnp 00:03: Plug and Play ACPI device, IDs PNP0c04 (active)
[ 0.310472] pnp 00:04: Plug and Play ACPI device, IDs PNP0200 (active)
[ 0.310520] pnp 00:05: Plug and Play ACPI device, IDs PNP0800 (active)
[ 0.310576] pnp 00:06: Plug and Play ACPI device, IDs PNP0b00 (active)
[ 0.310690] pnp 00:07: Plug and Play ACPI device, IDs PNP0103 (active)
[ 0.310749] pnp 00:08: Plug and Play ACPI device, IDs PNP0303 (active)
[ 0.310804] pnp 00:09: Plug and Play ACPI device, IDs SYN010f SYN0100 SYN0002 PNP0f13 (active)
[ 0.311066] system 00:0a: Plug and Play ACPI device, IDs PNP0c02 (active)
[ 0.311677] pnp 00:0b: Plug and Play ACPI device, IDs HPQ0004 (active)
[ 0.311845] system 00:0c: Plug and Play ACPI device, IDs PNP0c02 (active)
[ 0.312175] system 00:0d: Plug and Play ACPI device, IDs PNP0c02 (active)
[ 0.312190] pnp: PnP ACPI: found 14 devices
[ 0.312192] ACPI: ACPI bus type pnp unregistered
[ 0.312197] PnPBIOS: Disabled by ACPI PNP
[ 0.694522] acpiphp: ACPI Hot Plug PCI Controller Driver version: 0.5
[ 0.694789] acpiphp: Slot [1] registered
[ 1.209623] ACPI: Thermal Zone [TZ0] (43 C)
[ 1.245239] ACPI: Thermal Zone [TZ1] (47 C)
[ 1.245347] ACPI: Fan [C32D] (off)
[ 1.245425] ACPI: Fan [C32E] (off)
[ 1.245503] ACPI: Fan [C32F] (off)
[ 1.245582] ACPI: Fan [C330] (off)
[ 1.264245] ACPI: Thermal Zone [TZ2] (38 C)
[ 1.274458] ACPI: Thermal Zone [TZ3] (27 C)
[ 1.278192] ACPI: Thermal Zone [TZ4] (72 C)
[ 1.770523] ata1.00: ACPI cmd f5/00:00:00:00:00:a0 (SECURITY FREEZE LOCK) filtered out
[ 1.782791] ata1.00: ACPI cmd c6/00:10:00:00:00:a0 (SET MULTIPLE MODE) succeeded
[ 1.782796] ata1.00: ACPI cmd ef/10:03:00:00:00:a0 (SET FEATURES) filtered out
[ 1.830495] ata1.00: ACPI cmd f5/00:00:00:00:00:a0 (SECURITY FREEZE LOCK) filtered out
[ 1.842790] ata1.00: ACPI cmd c6/00:10:00:00:00:a0 (SET MULTIPLE MODE) succeeded
[ 1.842794] ata1.00: ACPI cmd ef/10:03:00:00:00:a0 (SET FEATURES) filtered out
[ 2.559585] ACPI: Requesting acpi_cpufreq
[ 2.573303] ACPI: Sleep Button [C249]
[ 2.573433] ACPI: Lid Switch [C241]
[ 2.578133] ACPI: acpi_idle registered with cpuidle
[ 2.579241] ACPI: Power Button [PWRF]
[ 2.608481] ACPI: AC Adapter [C1B2] (on-line)
[ 2.619330] [Firmware Bug]: ACPI: No _BQC method, cannot determine initial brightness
[ 2.620666] acpi device:01: registered as cooling_device6
[ 2.620899] ACPI: Video Device [C085] (multi-head: yes rom: no post: no)
[ 2.669097] ACPI: Battery Slot [C1B4] (battery present)
[ 2.669211] ACPI: Battery Slot [C1B3] (battery absent)
[ 3.865996] snd_hda_intel 0000:00:1b.0: power state changed by ACPI to D0
[ 3.866008] snd_hda_intel 0000:00:1b.0: power state changed by ACPI to D0
[ 7.577461] input: ACPI Virtual Keyboard Device as /devices/virtual/input/input11
나는 실행하여 lm_sensors구성 파일에 기억이 나지 않는 줄을 추가하도록 했지만 도움이 되지 않았습니다.
(편집: /etc/modules에 "loop"와 "coretemp"를 추가하고 서비스를 다시 시작하게 했습니다.)
AC 전원으로 실행할 때 BIOS에서 팬을 영구적으로 켤 수 있지만 10~20초마다 계속 켜고 끄는 것보다 필요할 때 켜거나 끄는 것이 좋습니다.