dhcpcd를 사용하여 DHCP에서 고정 IP로 전환하려고 합니다. 정적 주소에서 DHCP로 전환할 때 eth0(정적 주소 포함)도 DHCP 주소를 갖도록 구성했습니다. 그러나 어떻게든 dhcpcd는 시작 시 게이트웨이도 삭제하는 것 같습니다.
그래서 내가 원래 그랬다면
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
0.0.0.0 192.168.50.1 0.0.0.0 UG 0 0 0 eth0
192.168.50.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
그것은 될 것이다
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.50.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
이것은 내 dhcpcd.conf 파일입니다
# A sample configuration for dhcpcd.
# See dhcpcd.conf(5) for details.
# Allow users of this group to interact with dhcpcd via the control socket.
#controlgroup wheel
# Inform the DHCP server of our hostname for DDNS.
hostname
# Use the hardware address of the interface for the Client ID.
#clientid
# or
# Use the same DUID + IAID as set in DHCPv6 for DHCPv4 ClientID as per RFC4361.
# Some non-RFC compliant DHCP servers do not reply with this set.
# In this case, comment out duid and enable clientid above.
duid
# Persist interface configuration when dhcpcd exits.
persistent
# Rapid commit support.
# Safe to enable by default because it requires the equivalent option set
# on the server to actually work.
option rapid_commit
# A list of options to request from the DHCP server.
option domain_name_servers, domain_name, domain_search, host_name
option classless_static_routes
# Respect the network MTU. This is applied to DHCP routes.
option interface_mtu
# Most distributions have NTP support.
#option ntp_servers
# A ServerID is required by RFC2131.
require dhcp_server_identifier
# Generate SLAAC address using the Hardware Address of the interface
#slaac hwaddr
# OR generate Stable Private IPv6 Addresses based from the DUID
#slaac private
# Configure IPv4 only
ipv4only
# Don't set any default routes
nogateway
# Allow the following interfaces
allowinterfaces eth0
나는 dhcpcd eth0IP를 요청하는 데 사용
내가 뭘 잘못했나요?