파쇄가 중단된 후 USB 하드 드라이브를 마운트하는 방법

파쇄가 중단된 후 USB 하드 드라이브를 마운트하는 방법

관련 없는 사용자 유발 시스템 정지로 인해 파쇄 명령이 중단되었습니다.

이제 작동하지 않습니다 lsblk -l. 여러 Linux 시스템을 사용해 보았습니다.

이것답변(에서외장 하드 드라이브가 감지되었지만 인식되지 않았습니다. 마운트할 수 없음, 포맷할 수 없음, 파티션할 수 없음)는 외부의 힘을 지적하는데, 애초에 파쇄할 수 있었던 이후로 그것이 원인이라고 생각합니다.

journalctl -b

Nov 03 15:48:44 x kernel: usb 1-1.1.4: new high-speed USB device number 7 using ehci-pci
Nov 03 15:48:44 x kernel: usb 1-1.1.4: New USB device found, idVendor=174c, idProduct=55aa, bcdDevice= 1.00
Nov 03 15:48:44 x kernel: usb 1-1.1.4: New USB device strings: Mfr=2, Product=3, SerialNumber=1
Nov 03 15:48:44 x kernel: usb 1-1.1.4: Product: ASMT1051
Nov 03 15:48:44 x kernel: usb 1-1.1.4: Manufacturer: asmedia
Nov 03 15:48:44 x kernel: usb 1-1.1.4: SerialNumber: 123456789012
Nov 03 15:48:44 x kernel: usb-storage 1-1.1.4:1.0: USB Mass Storage device detected
Nov 03 15:48:44 x kernel: usb-storage 1-1.1.4:1.0: Quirks match for vid 174c pid 55aa: 400000
Nov 03 15:48:44 x kernel: scsi host6: usb-storage 1-1.1.4:1.0
Nov 03 15:48:44 x kernel: usbcore: registered new interface driver usb-storage
Nov 03 15:48:44 x kernel: usbcore: registered new interface driver uas
Nov 03 15:48:45 x kernel: scsi 6:0:0:0: Direct-Access     ASMT     2105             0    PQ: 0 ANSI: 6              
Nov 03 15:48:45 x kernel: sd 6:0:0:0: [sdb] Spinning up disk...
Nov 03 15:50:47 x kernel: sd 6:0:0:0: [sdb] Read Capacity(16) failed: Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
Nov 03 15:50:47 x kernel: sd 6:0:0:0: [sdb] Sense Key : Not Ready [current] 
Nov 03 15:50:47 x kernel: sd 6:0:0:0: [sdb] Add. Sense: Logical unit is in process of becoming ready
Nov 03 15:51:07 x kernel: sd 6:0:0:0: [sdb] Read Capacity(10) failed: Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
Nov 03 15:51:07 x kernel: sd 6:0:0:0: [sdb] Sense Key : Not Ready [current] 
Nov 03 15:51:07 x kernel: sd 6:0:0:0: [sdb] Add. Sense: Logical unit is in process of becoming ready
Nov 03 15:51:07 x kernel: sd 6:0:0:0: [sdb] 0 512-byte logical blocks: (0 B/0 B)
Nov 03 15:51:07 x kernel: sd 6:0:0:0: [sdb] 0-byte physical blocks
Nov 03 15:51:14 x kernel: sd 6:0:0:0: [sdb] Test WP failed, assume Write Enabled
Nov 03 15:51:21 x kernel: sd 6:0:0:0: [sdb] Asking for cache data failed
Nov 03 15:51:21 x kernel: sd 6:0:0:0: [sdb] Assuming drive cache: write through
Nov 03 15:51:21 x kernel: sd 6:0:0:0: [sdb] Spinning up disk...
Nov 03 15:53:22 x kernel: sd 6:0:0:0: [sdb] Read Capacity(16) failed: Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
Nov 03 15:53:22 x kernel: sd 6:0:0:0: [sdb] Sense Key : Not Ready [current] 
Nov 03 15:53:22 x kernel: sd 6:0:0:0: [sdb] Add. Sense: Logical unit is in process of becoming ready
Nov 03 15:53:43 x kernel: sd 6:0:0:0: [sdb] Read Capacity(10) failed: Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
Nov 03 15:53:43 x kernel: sd 6:0:0:0: [sdb] Sense Key : Not Ready [current] 
Nov 03 15:53:43 x kernel: sd 6:0:0:0: [sdb] Add. Sense: Logical unit is in process of becoming ready
Nov 03 15:53:57 x kernel: sd 6:0:0:0: [sdb] Attached SCSI disk
Nov 03 15:56:15 x kernel: sd 6:0:0:0: [sdb] Spinning up disk...
Nov 03 15:58:16 x kernel: sd 6:0:0:0: [sdb] Read Capacity(16) failed: Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
Nov 03 15:58:16 x kernel: sd 6:0:0:0: [sdb] Sense Key : Not Ready [current] 
Nov 03 15:58:16 x kernel: sd 6:0:0:0: [sdb] Add. Sense: Logical unit is in process of becoming ready
Nov 03 15:58:37 x kernel: sd 6:0:0:0: [sdb] Read Capacity(10) failed: Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
Nov 03 15:58:37 x kernel: sd 6:0:0:0: [sdb] Sense Key : Not Ready [current] 
Nov 03 15:58:37 x kernel: sd 6:0:0:0: [sdb] Add. Sense: Logical unit is in process of becoming ready

분쇄 명령:

sudo shred -vzn 0 /dev/sdb

lsblk-l

NAME      MAJ:MIN RM   SIZE RO TYPE  MOUNTPOINT
sda         8:0    0 119.2G  0 disk  
sda1        8:1    0   100M  0 part  /boot/efi
sda2        8:2    0   250M  0 part  /boot
sda3        8:3    0 118.9G  0 part  
luks      254:0    0 118.9G  0 crypt 
Arch-swap 254:1    0   512M  0 lvm   [SWAP]
Arch-root 254:2    0 118.4G  0 lvm   /

관련 정보