NetworkManager가 연결을 추가하지만 인터페이스를 설정하지 않습니다.

다음 명령을 실행하여 네트워크 관리자에 새 연결을 추가합니다.

nmcli con add con-name MIDVERCORP ifname wlan0 type wifi ssid "MIDVERCORP"

구성된 연결을 보면 이 새 연결이 추가되었지만 인터페이스/장치가 설정되지 않았습니다 wlan0.

# nmcli con
NAME                UUID                                  TYPE      DEVICE
eth0                1c71a54a-5ef1-4e32-ad02-8427f0168645  ethernet  eth0
eth1                57ce5d30-cde3-4b07-b83f-a5935f93cb6a  ethernet  eth1
MIDVERCORP          48e53a8a-ccbb-461e-bdca-74a837aa2c98  wifi      --
Wired connection 1  0eabbb3d-40d4-3031-a46e-14d87f9ac275  ethernet  --
Wired connection 2  fc12cba9-ee87-377d-ac4e-746a2f8fd6b3  ethernet  --
static-usb0         f93578c1-d309-4103-8554-fc1982ccda02  ethernet  --

# ip link show wlan0
5: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN mode DORMANT group default qlen 1000
    link/ether c0:ee:40:50:25:c0 brd ff:ff:ff:ff:ff:ff

이 연결을 위해 wlan0 인터페이스를 설정하려면 무엇이 빠졌습니까?

편집하다

Wi-Fi가 활성화되었음을 추가로 표시하려면 다음을 수행하세요.

# nm radio wifi on
# nm radio
WIFI-HW  WIFI     WWAN-HW  WWAN
enabled  enabled  enabled  enabled
# nm dev wifi rescan
Error: Scanning not allowed while unavailable or activating.
# ip link show wlan0
6: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN mode DORMANT group default qlen 1000
    link/ether c0:ee:40:50:25:c0 brd ff:ff:ff:ff:ff:ff
# ip addr show wlan0
6: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN group default qlen 1000
    link/ether c0:ee:40:50:25:c0 brd ff:ff:ff:ff:ff:ff