저는 Ubuntu 16.04를 사용하고 있으며 Intel 82575 칩셋이 포함된 PCI 듀얼 네트워크 카드를 설치했습니다. 카드가 인식되고 igb 드라이버가 카드에 할당되었지만 하나의 인터페이스만 활성화되었습니다.
이 두 인터페이스를 인식하도록 드라이버를 구성하려면 어떻게 해야 합니까?
02:00.0 Ethernet controller: Intel Corporation 82575EB Gigabit Network Connection (rev 02)
02:00.1 Ethernet controller: Intel Corporation 82575EB Gigabit Network Connection (rev 02)
ethtool -i enp2s0f1
driver: igb
version: 5.4.0-k
firmware-version: 1.115, 0x87850000
expansion-rom-version:
bus-info: 0000:02:00.1
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: yes
ip link show
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: enp1s0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast state DOWN mode DEFAULT group default qlen 1000
link/ether e0:d5:5e:b1:12:4f brd ff:ff:ff:ff:ff:ff
3: enp2s0f0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1520 qdisc mq master br0 state DOWN mode DEFAULT group default qlen 1000
link/ether 6c:b3:11:32:3e:d4 brd ff:ff:ff:ff:ff:ff
4: enp2s0f1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1520 qdisc mq master br0 state UP mode DEFAULT group default qlen 1000
link/ether 6c:b3:11:32:3e:d5 brd ff:ff:ff:ff:ff:ff
5: br0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1520 qdisc noqueue state UP mode DEFAULT group default qlen 1000
link/ether 6c:b3:11:32:3e:d4 brd ff:ff:ff:ff:ff:ff
문제 해결 위치에 대한 제안을 주시면 대단히 감사하겠습니다. 감사해요.