Fedora에서는 자동 완성이 작동하지 않습니다.

저는 페도라 25를 사용하고 있습니다. 터미널에서 Tab 키를 사용하여 자동 완성 기능이 작동하지 않는 것 같습니다.

예를 들어, 명령을 자동 완성하려고 하면 다음 메시지가 나타납니다.

sudo systemctl 시작 httpd.ser유닛 의류.서비스를 찾을 수 없습니다..

systemD 상태를 확인하고 이것을 발견했습니다.

$ sudo systemctl --state=not-found --all
  UNIT                            LOAD      ACTIVE   SUB  DESCRIPTION
● apparmor.service                not-found inactive dead apparmor.service
● fedora-autorelabel-mark.service not-found inactive dead fedora-autorelabel-mark.service
● fedora-autorelabel.service      not-found inactive dead fedora-autorelabel.service
● ip6tables.service               not-found inactive dead ip6tables.service
● ipset.service                   not-found inactive dead ipset.service
● iptables.service                not-found inactive dead iptables.service
● libvirt-guests.service          not-found inactive dead libvirt-guests.service
● lvm2-activation-early.service   not-found inactive dead lvm2-activation-early.service
● lvm2-activation.service         not-found inactive dead lvm2-activation.service
● nfs-secure-server.service       not-found inactive dead nfs-secure-server.service
● ntpd.service                    not-found inactive dead ntpd.service
● ntpdate.service                 not-found inactive dead ntpdate.service
● plymouth-quit-wait.service      not-found inactive dead plymouth-quit-wait.service
● plymouth-quit.service           not-found inactive dead plymouth-quit.service
● plymouth-read-write.service     not-found inactive dead plymouth-read-write.service
● plymouth-start.service          not-found inactive dead plymouth-start.service
● rpc-svcgssd.service             not-found inactive dead rpc-svcgssd.service
● sntp.service                    not-found inactive dead sntp.service
● syslog.service                  not-found inactive dead syslog.service
● ypbind.service                  not-found inactive dead ypbind.service
● syslog.target                   not-found inactive dead syslog.target

LOAD   = Reflects whether the unit definition was properly loaded.
ACTIVE = The high-level unit activation state, i.e. generalization of SUB.
SUB    = The low-level unit activation state, values depend on unit type.

21 loaded units listed.
To show all installed unit files use 'systemctl list-unit-files'.

이 문제를 해결하는 방법을 아는 사람이 있나요? 버그 추적기에 보고서를 보내야 합니까?